Race Face -> TREK BB92

Daniel Smith · Post by **Daniel Smith** » 23 Jan 2011, 21:02

Has anybody tried to install RACEFACE cranks on a press-in BB?

If I measure the standard RACEFACE BB, it measures 95mm (from seal to seal)...my TREK's integrated BB is 92mm (from seal to seal).

There is NO way I can get the RF arms to tighten into the seals - this was not a problem at all with my XT cranks...they could tighten into the 92mm.

Does this make sense? Let me know if diagrams are needed

Daniel Smith · Post by **Daniel Smith** » 02 Apr 2011, 10:59

Aarrggh - sorry, but I need to ask again

Nu har jeg købt RF's BB92 press-in kit:

I can remove TREK's bearings, but what about the cups? How the frick do I get them out? Other than that, I assume these press in with a headset tool...

Any help GREATLY appreciated!